46
Cleaning with Pyroluxe
1
Warning! The oven becomes very hot during this procedure. Children
must be kept well away.
1
Important: All slide-in parts must be removed from the oven before
cleaning with pyroluxe.
3
If you use the oven shelf runners obtainable as special accessories,
they must be removed before cleaning with pyroluxe.
It is not possible to start the pyroluxe cleaning process because of a
safety switch that protects the oven shelf runners.
1. Remove thick deposits in advance by hand.
2. Set the oven function switch to py-
roluxe P.
3. Turn the temperature selection
switch clockwise as far as it will go.
Pyroluxe cleaning will begin after a
few seconds and will switch itself
off again automatically after 2
hours 30 minutes.
3
During pyroluxe cleaning the door is locked and the oven lighting is
off. The temperature pilot light will stay on until the door lock is re-
leased again.
4. When pyroluxe cleaning has been completed, turn all switches to the
off position.
5. After it has cooled down, wipe out the oven with a damp cloth.
To Next Page
Loading...
