AEG DDLE LCD 18 - 8 Special Accessories

34
For contractors
• Direct tap instantaneous water heaters
ADEo 70 WD - mono-lever mixer tap with changeover bath/hand shower
Part no. 18 39 34
• Installation accessories
Pipe assembly undersink installation UT 104
Part no. 18 44 21
 Waterconnectionswith12mmcompressionttings
• Universal mounting frame
Part no. 22 77 01
Comprising:
– Mounting frame with
– electrical wiring.
This assembly creates a gap of 30 mm between the device back panel and the installation wall.
 Thisenablestheelectricalconnectiontoberoutedoverunnishedwallsatanypointbehindthe
equipment. This increases the equipment depth by 30 mm. This set reduces the protection to IP 24 (splash-
proof).
• Offset installation set for unnished walls
Part no. 22 77 02
Comprising:
 – Universalmountingframe(forspecicationseepartno.227701).
– Pipe bends for a vertical offset of the device relative to the water connection by 90 mm downwards.
• Pipe assembly, replacement of a gas red water heater
Part no. 22 77 03
Comprising:
 – Universalmountingframe(forspecicationseepartno.227701)
- Pipe bends for the installation with existing gas water heater connections (cold water on the left and
DHW on the right).
• Automatic maximum demand controller LR 1-A
Part no. 00 17 86
Priority control of the instantaneous water heater when operating, for example, electric storage heaters
simultaneously. For connection of the LR 1-A, see
L
.
8. Special accessories