10.3 Filling the detergent and
additives
- Compartment for prewash phase,
soak programme or stain remover.
- Compartment for washing phase.
- Compartment for fabric softener and
other liquid treatments(fabric conditioner,
starch).
- Maximum level for quantity of liq-
uid additives.
- Flap for powder or liquid deter-
gent.
Always follow the
instructions that you find on
the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum
indicated level ( ). This
quantity will however
guarantee the best washing
results.
After a washing cycle, if
necessary, remove any
detergent residue from the
detergent dispenser.
10.4 Check the position of the
detergent flap
1. Pull out the detergent dispenser until
it stops.
2.
Press the lever down to remove the
dispenser.
3. To use powder detergent, turn the
flap up.
4. To use liquid detergent, turn the flap
down.
With the flap in the position DOWN:
• Do not use gelatinous or thick
liquid detergents.
• Do not exceed to liquid
detergent dose indicated on the
flap.
• Do not set the prewash phase.
• Do not set the delay start
function.
5. Measure out the detergent and the
fabric conditioner.
6. Carefully close the detergent
dispenser.
www.aeg.com
32
To Next Page
Loading...
Need help?
General
Weight and Dimensions
