11.1 Complete wash&dry
programme
Automatic Non-Stop
programme or programmes
Depending on the model, the appliance
may be equipped with one or more
NonStop 60min programmes, automatic
wash&dry programmes where it is not
necessary to set the Mode - Dry.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Set the NonStop 60min programme
by means of the programme dial.
The indicators and appear on
the display.
3. Touch the Start/Pause button to start
the programme.
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Mode - Wash and Mode - Dry
for running a complete wash&dry
programme.
Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme. The appliance
defaults to the washing only mode
and the indicator of the Mode - Wash
button is on. The display shows the
default temperature and spin. If
necessary, change them according to
your laundry. The display also shows
the maximum recommended load for
washing phase.
5. Set the desired options, if there are
available.
6. Tap on the Mode - Dry button to
activate also the drying function.
Both indicators of the Mode - Wash
and Mode - Dry buttons are on. The
indicators and appear on the
display. The display also shows the
maximum recommended load for a
washing and drying programme (e.g.
4 kg for cottons).
11.2 Washing and Drying -
Automatic levels
1. Tap on the Auto Dry button
repeatedly until the display shows
the required dryness level. The
indicators in the display illuminate
accordingly:
a. Iron dry: for cotton items;
b. Cupboard dry: for cotton and
synthetic items;
c. Extra dry: for cotton items.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load
size.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button Start/Pause to start the
programme. The AutoAdjust
estimation starts.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.
11.3 Washing and Timed
Drying
1. Tap on the Time Dry button
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator
goes off and
the indicator comes on.
Each time you tap on this button the
time value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start/Pause button to start
the programme. The AutoAdjust
estimation starts.
In the display the door locked
indicator comes on.
www.aeg.com
36
To Next Page
Loading...
Need help?
General
Weight and Dimensions
