EasyManuals Logo

AEG L7WC8632BI User Manual

AEG L7WC8632BI
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
The door unlocks and the indicator
goes off.
1. Press button On/Off to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
10.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
The time area shows and the
display shows the door locked
.
The indicator of the Start/Pause
button starts flashing.
The drum still turns at regular intervals
to prevent creases in the laundry.
The door stays locked.
You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed
by the appliance.
2. Press the Start/Pause button: the
appliance drains the water and spins.
The option indicator Rinse Hold
disappears.
If you have selected No Spin
, the appliance will
only drain the water.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
10.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
You do not use the appliance for 5
minutes when no programme is
running.
Press the button On/Off to activate
the appliance again.
5 minutes after the end of the
washing programme.
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset"
position
, the appliance automatically
turns off in 30 seconds.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
ENGLISH 35

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AEG L7WC8632BI and is the answer not in the manual?

AEG L7WC8632BI Specifications

General IconGeneral
Door hingeLeft
Drum volume52 L
Loading typeFront-load
Product colorWhite
Built-in displayYes
Custom panel-ready-
Appliance placementBuilt-in
Annual water consumption washing11200 L
Annual energy consumption washing194 kWh
Annual water consumption washing & drying23000 L
Annual energy consumption washing & drying1060 kWh
Drying capacity84 kg
Washing capacity8 kg
Residual moisture44 %
Maximum spin speed1600 RPM
Noise level (spin)70 dB
Noise level (wash)46 dB
Noise level (drying)52 dB
Inlet hose length1.5 m
Outlet hose length1.4 m
Connected load2000 W
AC input voltage230-240 V
AC input frequency50 Hz
Energy efficiency scaleA to G
Energy consumption washing per cycle0.97 kWh
Water consumption washing & drying per cycle- L
Energy consumption washing & drying per cycle5.3 kWh
Weight and Dimensions IconWeight and Dimensions
Depth540 mm
Width596 mm
Height819 mm

Related product manuals