7.7 Start/Pause
Touch the Start/Pause button to start,
pause the appliance or interrupt a running
programme.
7.8 Plus Steam
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme.
The steam phase reduces fabric creasing and
facilitates the fabric ironing.
The Plus Steam option achieves good results
with a small load because steam better
penetrates the laundry if there is more space.
For this reason, the programme maximum
load combined with this option is 2 kg
(approximately 8 - 10 shirts).
When setting the Plus Steam option, the
maximum load drops to 2 kg in the display
and programme time is adjusted accordingly.
The indicator blinks in the display during
steam phase.
This option can affect the programme
duration.
When the programme stops the display
shows a zero , the indicator is steady
on.
The anti-crease phase starts, the indicator
is blinking, and the Start/Pause led
remains lit. The drum performs smooth
movements for about 30 minutes to keep the
steam benefit.
To interrupt the anti-crease phase, you can:
• Press the On/Off button for a few seconds
to activate or the deactivate the appliance.
• Turning the programme dial in another
position.
When the anti-crease movements stop and
the door unlocks, the appliance proposes
again the previous set programme.
A small laundry load helps to reach better
results.
7.9 Extra Rinse
With this option you can add a few rinses to
the selected washing programmes and
optimise the fabric softener distribution and
improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents and in
areas where the water is soft.
This option increases the programme
duration.
The button indicator comes on.
7.10 Time Save
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly soiled,
it may be advisable to shorten the washing
programme. Touch this button once to
decrease the duration.
• In case of smaller load, touch this button
twice to set an extra quick programme.
In this case, the temperature 95°C is not
selectable.
The led of the button is on and the display
shows the set programme duration.
This option can also be used to shorten
the steam programme duration.
7.11 Stains/Prewash
Press this button repeatedly to activate one of
the two options or both.
The relevant indicator goes on in the display.
• Stains
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in the
appropriate phase of the washing
programme.
ENGLISH 17
To Next Page
Loading...
