7. Remove the polystyrene protection from
the bottom.
8. Pull up the appliance in vertical position.
9. Remove the power supply cable and the
drain hose from the hose holders.
It is possible to see water flowing
from the drain hose. This is due to
the testing with water of the appliance
in factory.
10. Remove the three bolts by using the
spanner supplied with the appliance.
11. Pull out the plastic spacers.
12. Put the plastic caps, that you find in the
user manual bag, in the holes.
We recommend that you keep the
packaging and the transit bolts for any
movement of the appliance.
5.2 Positioning and levelling
1. Install the appliance on a flat hard floor.
Make sure that carpets do not stop the
air circulation below the appliance.
Make sure that the appliance does not
touch the wall or other units.
ENGLISH 9
To Next Page
Loading...
