EasyManua.ls Logo

AEG LFR7314O4C - 14.10 Cleaning the inlet hose and the valve filter

AEG LFR7314O4C
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
1
12. Close the pump cover.
2
1
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
a. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
b. Start the programme to drain the
water.
14.10 Cleaning the inlet hose and
the valve filter
It is recommended to clean both the filters of
the inlet hose and valve occasionally to
remove any deposit, collected over the time:
1. Remove the inlet hose from the tap and
clean the filter.
1
2
3
2. Remove the inlet hose from the appliance
by loosening the ring nut.
3. Clean the valve filter on the back of the
appliance with a toothbrush.
4. When you reconnect the hose to the back
of the appliance, turn it left or right (not in
vertical position) depending on the
position of your water tap.
40 ENGLISH

Table of Contents

Related product manuals