quarter (from 1 to 4, 4 bars in case of
overload), the maximum declared load
indicator comes on again. After further 30
seconds, the water filling starts.
In case of in case of drum overload,
the maximum declared load indicator
comes on again with the
indicator blinking. In this case, during
these 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding
garments, touch the Start/Pause
button to start the programme again.
The ProSense phase can be
repeated up to three times (see point
1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The ProSense detection is carried out
with complete washing programmes only
(no skipping phase selected).
The ProSense is not available with some
programmes, such as Wool, programmes
with short cycles and without washing
phase.
12.9 Programme phase indicators
When the programme starts the indicator of
the running phase flashes and the other
phase indicators are steady on.
E.g. the washing or pre wash phase is
running: .
When the phase ends the relevant indicator
stops flashing and is steady on. The next
phase indicator starts flashing.
E.g. the rinse phase is running: .
If you select the Plus Steam the steam phase
indicators come on.
The steam phase is running: .
The anti-crease phase is running: .
12.10 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start/Pause button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Start/Pause button again.
The washing programme continues.
12.11 Cancelling a running
programme
1. Press the On/Off button to cancel the
programme and to deactivate the
appliance.
2. Press the On/Off button again to activate
the appliance.
Now, you can set a new washing programme.
If the ProSense phase is already carried
out and the water filling is already
started, the new programme starts
without repeating the ProSense phase.
The water and the detergent are not
drained out in order to avoid waste. The
display shows the maximum duration of
the programme, updating it about 20
minutes after the starting of the new
programme.
32 ENGLISH
To Next Page
Loading...
