12.12 Opening the door - Adding
garments
While a programme or the delay start
operates, the appliance door is locked.
If the temperature and level of the water
in the drum are too high and/or the drum
still rotates you cannot open the door.
You can easily open the door for adding or
removing some items when the icon is
lighted on.
1. Touch the Start/Pause button.
In the display the related door lock indicator
goes off.
2. Open the appliance door. If necessary,
add or remove the items.
3. Close the door and touch the Start/Pause
button.
The programme or the delay start continues.
When the icon goes off, the door can be
opened when the programme is complete.
You may also set a spinning or draining
programme/option and than press Start/
Pause button. If the spin and drain
programmes are not available in the
programme dial, they can be set via App.
12.13 End of the programme
When the programme has finished, the
appliance stops automatically. The acoustic
signals operate (if they are active).
In the display all washing phase indicators
become steady and the time area shows .
The indicator of the Start/Pause button
goes off.
The door unlocks and the indicator goes
off.
1. Press the On/Off button to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last
selected programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent mildew
and odours.
5. Close the water tap.
12.14 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The display shows the indicator , the
option indicator or and the door
locked indicator
. The indicator of the
running phase flashes.
• The drum still turns at regular intervals to
prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed by the
appliance.
2. Touch the Start/Pause button:
• If you have set , the appliance
drains the water and spins.
• If you have set , the appliance only
drains the water.
The option indicator or goes off, while
the indicator
flashes and then goes off.
3. When the programme is completed and
the door locked indicator goes off,
you can open the door.
4. Press the On/Off button a few seconds to
deactivate the appliance.
In any case, the appliance empties the
water out automatically after
approximately 18 hours.
ENGLISH 33
To Next Page
Loading...
