AEG PROTECT 1 Series - Technical Data

12
2.3 Technical Data
Type rating
PROTECT 1.100 10000 VA (cos ϕ = 0.7 ind.)
7000 W
PROTECT 1.150 15000 VA (cos ϕ = 0.7 ind.)
10500 W
PROTECT 1.200 20000 VA (cos ϕ = 0.7 ind.)
14000 W
UPS input 3ph~ / N / PE
Rated connection voltage 400 V/ 230 VAC
Voltage range without 304 VAC – 478 VAC ± 3 %
battery operation (rectifier)
176 VAC – 261 VAC VAC ± 3 %
(bypass)
Frequency 50 Hz / 60 Hz
(autom. detection)
Frequency tolerance range ± 4 Hz
Current consumption at full load (max.)
PROTECT 1.100 13 A (3ph~) / 46 A (bypass)
PROTECT 1.150 19 A (3ph~) / 68 A (bypass)
PROTECT 1.200 25 A (3ph~) / 91 A (bypass)
System disturbance factor λ ≥ 0.95
UPS output
Nominal voltage output 220 / 230 / 240 VAC ± 1%
(configuration via
“CompuWatch” software )
Nominal frequency 50 Hz / 60 Hz ± 0.1%
(dependent on mains frequency)
Type of voltage Sine, distortion
≤ 2% THD (linear load)
≤ 6% THD (non-linear load)
Crest factor 3:1