42
Wet vacuum cleaning
Preparation
0 Prior to wet vacuuming always ensure that the
paper filter, the fine paper filter and the foam
filter have been removed.
The motor protection filter must always be
inserted into the suction hole.
The thin hose attached to the motor head is
required only for spray vacuum cleaning.
When wet vacuum cleaning, press the end of the
hose into the retainer located on the motor
head.
0 Check that the flotation valve under the motor
protection filter is working. The flotation ball
must always be clean and be able to move freely
in the filter basket. Check that the ball can move
around by shaking the motor head.
Prior to wet vacuuming, empty any dust from
the dust container.
Attach the motor head
0 Attach the motor head on the dust container
such that the switch is located vertically above
the suction hole.
Then press the two vice action latches.
To Next Page
Loading...
Need help?
General
