OUTPUT OPERATION ANNOUNCER (Location 72)
(1) LOCATION
Key in Location
(2) FUNCTION MODES FOR OUTPUT ANNOUNCER
Output announcer gives notification beep on the operation status of the outputs. There are two
notification modes available for the selection.The notification is also OFF while the Pacifier Tone OFF
mode in the Location 71 is selected.
--- No Notification
The output operation notification is OFF but does note affect the normal pacifier tones.
--- 1 Second Long Notification -- (Default)
--- 2 Short Beeps Notification
2 short beeps notification is given when the output relay activates.
(3) VALIDATION
Press
key once. Two-beeps confirms the entry
STATUS LED FLASHING ON-OFF DURING STANDBY (Location 73)
(1) LOCATION
Key in Location
(2) FUNCTION MODES FOR STANDBY FLASHING LIGHT
Some people find the flashing light of the status LED (the amber LED) is annoying during standby,
especially at the night time. The standby flashing can be ON-OFF with the setting here.
--- Standby Flashing ON -- (Default)
The Status LED gives Standby Flashing all the time. It also gives the light indications showing
the operation status of the system.
--- Standby Flashing OFF
The Standby Flashing is OFF but it does not affect the system status indications.
(3) VALIDATION
Press
key once . Two-beeps confirms the entry
FUNCTION MODES VALIDATIONLOCATION
or
(2) (3)(1)
FUNCTION MODES VALIDATIONLOCATION
or
(2) (3)(1)
COMMON USER CODE FOR OUTPUT 1 (Location 03)
The Common User Code 1 is prepared for operating Output 1 as an enhance code. The Common
User Code MUST work in the form of “Card + Common Code” to operate the output to increase the
security of the access control system. See Media 4 at Location 10 for more information.
NOTE: Common User Code alone can NOT operate the Outputs directly.
LOCATION COMMON USER CODE VALIDATION
(1) LOCATION
-- Location Stores The Common User Code for Output 1
(2) COMMON USER CODES
The Common User Code can be 4 to 8 digits.
When a new Common User Code is keyed in and confirmed, the old one is replaced.
(3) VALIDATION
Pressing key to confirm code entry.
Example:
a) Set a Common User Code “1 3 5 7” for Output 1 ----
b) Deleted a Common User Code from memory: Key in the Location number and #. ----
4 to 8 Digits
(1) (2)
(3)
NOTE:
In multi-station operation, the output announcer only goes to the keypad that has been operated but
not all the keypads in the system.
1 second notification beep is given when the output relay activates. It is prepared to notify
the person outside the door when the lock is released and the door can be opened. It is
good for door lock that gives no sound when it activates, such as a magnetic lock.
To Next Page
Loading...
