Aeon Labs Aeotec - Automatic Report Interval Settings (Parameters 111-113)

1 reset parameter 101-103
Parameter 101: Setting automatic report flags Group 1
Example: 1 + 1024 = Value 1025 If you want to report everthing, you would add the whole table together and set in to
101.
Please, see table in usage.
Size: 4 Byte, Default Value: 0
Setting Description
1 Report Total HEM – KWH
2 Report Total HEM – Watt
4 Report Total HEM – Voltage
8 Report Total HEM – Current
Parameter 102: Setting automatic report flags Group 2
Example: 1 + 1024 Value 1025 If you want to report everthing you would add the whole table together and set in to
102
Setting Description
1 Report Total HEM – KWH
2 Report Total HEM – Watt
4 Report Total HEM – Voltage
8 Report Total HEM – Current
Parameter 103: Setting automatic report flags Group 3
Example: 1 + 1024 = Value 1025 If you want to report everthing, you would add the whole table together and set in to
103.
Please, see table in usage.
Size: 4 Byte, Default Value: 0
Setting Description
1 Report Total HEM – KWH
2 Report Total HEM – Watt
4 Report Total HEM – Voltage
8 Report Total HEM – Current
Parameter 110: Reset parameter 111-113
Size: 1 Byte, Default Value: 0
Setting Description
1 reset parameter 111-113
Parameter 111: Setting an automatic report interval
Set the report intervall for Group 1
Size: 4 Byte, Default Value: 0
Setting Description
1 – 2097152 seconds
Parameter 112: Setting an automatic report interval
Set the report intervall for Group 1
Size: 4 Byte, Default Value: 0
Setting Description
1 – 2097152 seconds
Parameter 113: Setting an automatic report interval
Set the report intervall for Group 1
Size: 4 Byte, Default Value: 0
Setting Description
1 – 2097152 seconds