placed vertically with the wires protruding from the bottom of the unit.
To place the Home Energy Meter:
1. Unslot the backing plate from the back of your meter.
2. Affix the plate to the selected wall space using the provided screws.
3. Attach your meter to the backing plate.
Diagram of EU/AU Version (3 Phases, 4 Wires):
Incoming Power Lines 180V to 260V,
MAX 60 A, Main Circuit Breaker,
Neutral, Bus, Blue, Brown, Phase A, B,
C, AC Power, HEM, Clamp Direction
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing
wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the
primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion
and Exclusion is then performed doing a special manual action right on the device.
Inclusion
– Push the button on backside
Exclusion
– Push the button three times on backside
Product Usage
Setting Parameter 101 -103
Byte#
Decimal
Value
Output Clamp#
HEM
Restriction
byte 4 1 kWh
Total
Readings
byte 4 2 Watt
Total
Readings
To Next Page
Loading...
Need help?
General
