EasyManuals Logo

Aeon Labs Aeotec User Manual

Aeon Labs Aeotec
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
byte 1 33554432 kVah Clamp 2
Gen5
Only
byte 1 67108864 kVah Clamp 3
Gen5
Only
byte 1 134217728 kVar Clamp 1
Gen5
Only
byte 1 268435456 kVar Clamp 2
Gen5
Only
byte 1 536870912 kVar Clamp 3
Gen5
Only
byte 1 1073741824 Reserved
byte 1 2147483648 Reserved
Quick trouble shooting
Here are a few hints for network installation if things dont work as expected.
1. Make sure a device is in factory reset state before including. In doubt exclude before include.
2. If inclusion still fails, check if both devices use the same frequency.
3. Remove all dead devices from associations. Otherwise you will see severe delays.
4. Never use sleeping battery devices without a central controller.
5. Dont poll FLIRS devices.
6. Make sure to have enough mains powered device to benefit from the meshing
Association – one device controls an other device
Z-Wave devices control other Z-Wave devices The relationship between one device controlling another device is
called association In order to control a different always related to certain events (e.g. button pressed, sensor triggers,
…). In case the event happens all devices stored in the respective association group will receive the same wireless
command wireless command, typically a ‘Basic Set’ Command.
Association Groups:

Other manuals for Aeon Labs Aeotec

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Aeon Labs Aeotec and is the answer not in the manual?

Aeon Labs Aeotec Specifications

General IconGeneral
BrandAeon Labs
ModelAeotec
CategorySecurity System
LanguageEnglish

Related product manuals