APPENDIX A
ii
SECONDARY MENU ITEM DESCRIPTIONS
CONSTANT SETPOINT
FUNC
OSAT
Oat
LLT
Hlt
Pb1
This indicates the mode of operation
the temperature controller is in.
Common modes are Oart,
indoor\outdoor reset, Cont, constant
setpoint, and FDFO for a water
heater.
This menu item turns the outside air
enable\disabl feature on or off. When
ON, an ouside air temperature can be
chosen to enable or disable the unit.
This displays the outside air
temperature that the unit is enabled.
This parameter is displayed only
when OSAT is on.
This is Low Limit Temperature. It is
the minimum value that the Setpoint,
(SetP), can be set to. To adjust, use
the and arrow keys. Press ENTER
to accept any changes.
This is High Limit Temperature. It is
the maximum value that the Set point
(SetP) can be adjusted to. To adjust,
use the and arrow keys. Press
ENTER after making changes.
Proportional Band refers to the error
between the setpoint and the actual
water temperature.
To Next Page
Loading...
Need help?
General
