APPENDIX A
v
Hlt
Pb1
Int
Drt
Addr
LOre
This is High Limit Temperature alarm.
This feature shuts down the unit and
places the temperature controller into
alarm if the outlet water temperature
exceeds this setting. Outlet water
temperature must be below this
setting before the unit will restart
Proportional Band refers to the error
between the setpoint and the actual
water temperature.
This is the integral rate, in minutes,
for the feedback of the controller. It is
adjusted with the arrow keys.
Press ENTER to accept changes.
This is the derivative rate in
% /.1°/sec. This adjusts response
time to temperature changes at the
outlet of the unit.
This displays the address for the
controller. It is used for external
communication with a computer.
This changes the local/remote status
of the controller. In local mode all
external computer write commands
are ignored. Read commands still
function. In remote both read and
write commands from an external
computer will function.
To Next Page
Loading...
Need help?
General
