39
Warning;
Biological hazard
Electricity
Wear head
protection
Wear ear protection
Wear eye protection
Warning;
Sharp element
Wear protective
gloves
Wear safety
footwear
Warning; Warning; Warning;
Flammable material
Warning;
Hot surface
ve the instruments and close the cooling circuit compartment.
The high/low pressure switch, where present must be tested with the
machine “closed”, reading the high pressure circuit pressure on the machine
control panel.
In case of machines with the cooling circuit compartment not closed by fra-
mework, the high/low pressure switch must be tested by standing in front
of the machine panel where the control panel is located, remaining distant
and not exposed to the under pressure parts of the cooling circuit.
CLEANING COIL MICRO-CHANNEL
Keep surfaces clean battery mirco-channel is critical to maintaining the
refrigeration systems at optimum performance levels.
Dirt, grease, oil, and other foreign material must be removed periodically
from the surface of the battery according to the following recommenda-
tions.
Required elements:
• Personal protective equipment
• Hot water
• High-pressure washing
Procedure: Use a high-pressure washer with a large cast and enough
force to remove all foreign material. Proceed with care to avoid damage
and possible wear of the ns.
Rinse thoroughly with water all the cleaning material from the battery
and surrounding equipment, including the fan and carpentry.
To Next Page
Loading...
Need help?
General
