AERMEC ANL202H User Manual

18.01. 6755441_03
INSTALLATION MANUAL
CHILLERS
REVERSIBLE HEAT PUMPS
CONDENSING UNITS
• EXTERNAL UNITS
• HIGH EFFICIENCY
• HOT WATER PRODUCTION UP TO 50 °C
Aermec
participates in the EUROVENT Programme: LCP.
The products of interest can be found on:
www.eurovent-certification.com
EN
ANL
ANL-H
020-202

AERMEC ANL202H Specifications

General

Brand	AERMEC
Model	ANL202H
Category	Heat Pump
Language	English

Summary

1. GENERAL INSTRUCTIONS FOR THE INSTALLER

1.2. SAFETY INSTRUCTIONS AND INSTALLATION STANDARDS

Guidelines for installer safety, unit installation, and compliance with national standards.

2. SELECTION AND POSITION OF INSTALLATION

2.2.1. POSITIONING

4. TYPICAL HYDRAULIC CIRCUITS

4.4. SYSTEM EXAMPLE FOR DHW PRODUCTION WITH ANL50H" WITH ACCESSORY VMF-ACS

4.5. SYSTEM CHARGING

4.6. SYSTEM DRAINING

5. ELECTRICAL CONNECTIONS

MANDATORY REQUIREMENTS

Essential requirements for electrical connections, including circuit breakers and earthing.

6. ELECTRICAL DATA

7. ELECTRICAL POWER SUPPLY CONNECTIONS

Instructions for connecting the unit to the power supply, including safety checks.

8. CHECKS AND FIRST START-UP

8.1. PREPARING FOR FIRST START-UP

8.2. START-UP

Steps for initiating the unit start-up sequence and preliminary checks.

8.2.1. PRELIMINARY CHECKS BEFORE POWERING UP

8.2.2. CHECKS TO BE DONE WHEN POWERED UP

Checks to perform on the unit after power has been supplied.

8.3. FIRST START-UP

Detailed steps for the initial start-up of the unit after all checks are completed.

8.3.1. CHECKS WITH THE UNIT RUNNING

Checks to perform on various circuits while the unit is in operation.

9. OPERATING CHARACTERISTICS

9.5. ANTI-FREEZE ALARM

9.6. WATER FLOW ALARM

10. ROUTINE MAINTENANCE

10.1. HYDRAULIC CIRCUIT

10.2. ELECTRIC CIRCUIT

10.3. REFRIGERANT CIRCUIT

11. SPECIAL MAINTENANCE

13. PROCEDURE FOR SELECTION OF SYSTEM TYPE

13.1. HOW TO MODIFY A USER MENU PARAMETER

13.2. HOW TO MODIFY AN INSTALLER MENU PARAMETER