21.01 5723611_01 37
— Identify the clamps for the electric connection and always refer exclusively to
the wiring diagram supplied with the unit;
— Remove any protections from the cable xing points;
— For the functional connection of the unit, take the power supply cable to the
electric control board inside the unit and connect it to clamps. L1-L2-L3, N
and PE respecting the polarities L1-L2-L3 and N as phases, and PE as ground-
ing(Electrical panel view - FIGURE C);
— Ensure that all protections removed for the electric connection have been re-
stored before powering the unit electrically;
— Close all the opened panels;
— Turn the switch at "ON" position;
— Position the system master switch (outside the appliance) at "ON";
— For auxiliary connection please refer to the wiring diagrams supplied with the
unit.
Electrical panel view - FIGURE C
TS35
TS35
TS35 T S35
TS35
TS35
TS35 TS35
TS35
X0230
X24
X024
X230
XTM
XS C 1
KMF1C
MVQ1
MVQ2
KMF1D
QMCP1A
40x80 (L370)
40x80 (L405)
40x80 (L405)
J1.G
JPE C.1
40x80 (L345)
X. L1 ( IN)
QMCP1B
QMF1A
40x80 (L985)
TM2
QMF1B
X. L3 ( IN)
QS1
X. L2 ( IN)
INV-C P1A
25x80 (L805)
25x80 (L795)
40x80 (L432.5)
40x80 (L460)
40x80 (L795)
25x80 (L505)
VC P 1A
VC P 1B
QMF1C QMF1D
KMF1BKMF1A
KMCP1B
KMCP1A
KA8
KA7
KA6
25x40 (L472.5)
KA5
FU4
XGP E
XS C F
XS C E V 1
XE C 1
40x80 (L335)
40x80 (L235)
QMPE 1
KAMPE 1
FE 3
FE 2
FE 1
XS C E V 2
R C S
FU2
TE 1
QF3
KA1
KA2
XS C 2
KA3
KA4
XA24XA230 XAS
XBP
XC XCS
XMF1A XMF1B XMF1C XMF1D
XMPE 1
XVEXS
6/6
8/7
14/2
14/3
8/8
6/3
21/2
36/2
5/4
7/2
8/2
17/5
8/4
5/45/4
6/5
6/6
7/2
9/2 9/4
8/68/5
7/3
6/2
19/7
19/6
20/2
28/4
13/2
26/5
41/5
36/6
12/2
12/7
6/5
6/4
5/2
43/5
13/2
17/5
14/2
13/3
15/2
15/4
6/8
18/3
33/3
L1
PE
L2L3 N
1
PE
The installer can act on terminals XC and XCS
To Next Page
Loading...
