Do you have a question about the aermotor CT35-3-200 and is the answer not in the manual?
Section for recording pump model, serial number, and installation details.
Illustrates proper and improper pump piping configurations for optimal performance.
Advice on pipe sizing, support, and general installation practices for pumps.
Specific recommendations for suction pipe sizing and connection based on pump tapping.
Specific recommendations for discharge pipe sizing and connection based on pump tapping.
Step-by-step instructions for evacuating air and filling the pump and suction line with water.
Diagrams for converting 230V motors to 115V operation and general wiring.
Essential safety guidelines and procedures for electrical connections and motor operation.
Detailed steps for removing the old shaft seal and installing new floating and rotating seal components.
List of motor and horsepower-related components for CT35 Series High Head pumps.
Details on the available Seal and Gasket Kit for servicing CT35 Series pumps.
List of motor and horsepower-related components for CT45 Series Medium Head pumps.
Details on the available Seal and Gasket Kit for servicing CT45 Series pumps.
List of motor and horsepower-related components for CT45 Series Medium Head 1-1/2 HP pumps.
Details on the available Seal and Gasket Kit for servicing CT45 Series pumps.
Table of common pump problems, their causes, and recommended solutions.
Details of Aermotor's warranty coverage, terms, and conditions for their products.
| Model | CT35-3-200 |
|---|---|
| Category | Water Pump |
| Type | Centrifugal Pump |
| Power Source | Electric |
| Material | Cast Iron |
| Phase | Three Phase |
Loading...