Aeroflex 2945A - MI-BASIC Programs

EDACS REPEATERS
1-8
MI-BASIC programs
This section defines what tests are to be run in the built-in test programs.
Quick Testing
if enabled TEST HSDEVN
if enabled TEST DATAPERFORM
TEST TESTSETCALL
if enabled TEST LSDEVN
if enabled TEST RFSINAD
if enabled TEST RFDISTN
if enabled TEST RFSN
if enabled TEST TXFREQ
if enabled TEST TXLEVEL
TEST TESTSETCLEAR
General Testing
TEST RADIOCALL
TEST RADIOCLEAR
if enabled TEST HSDEVN
If enabled TEST DATAPERFORM
TEST TESTSETCALL
if enabled TEST LSDEVN
if enabled TEST RFSINAD
if enabled TEST RFDISTN
if enabled TEST RFSN
if enabled TEST TXFREQ
if enabled TEST TXLEVEL
if enabled TEST TXSINAD
if enabled TEST TXDISTN
if enabled TEST TXSN
if enabled TEST TXNOISE
if enabled TEST TXLIMIT
if enabled TEST TXCOMPRESS
if enabled TEST RXSINAD
if enabled TEST RXDISTN
if enabled TEST RXSN
if enabled TEST RXSENS
if enabled TEST RXEXPAND
TEST TESTSETCLEAR
User-defined test
The user-defined test program facility allows you to run
your own test program. This is written on a PC or other
programming equipment using the MI-BASIC language,
then loaded into the Service Monitor.