Aeroflex 2945A - Autorun Parameter Settings

EDACS REPEATERS
1-4
Autorun parameter settings
These are the default parameters for all of the available auto tests for EDACS. These parameters
are used by the tests (called from MI-BASIC), or they can be accessed directly by MI-BASIC.
The list on the right-hand side of the page shows the equivalent MI-BASIC commands for the
parameters. If you modify these parameters, these defaults can be restored by using the
appropriate command in the HELP/SETUP menu.
Note that deviations returned in automatic tests are peak measurements only. Manual
measurements can return peak or RMS results.
Call from radio TEST RADIOCALL
RF generator level -30 dBm RFGENLEVEL <expr> [<units>]
Timeout 30s TIMEOUT <expr> [<units>]
Use accessory port ON USEACCPORT {ON/OFF}
Set accessory port logic 1 ACCPORT {LOGIC0/1/2/3}
Clear from radio TEST RADIOCLEAR
RF generator level -30 dBm RFGENLEVEL <expr> [<units>]
Timeout 30s TIMEOUT <expr> [<units>]
Use accessory port ON USEACCPORT {ON/OFF}
Set accessory port logic 2 ACCPORT {LOGIC0/1/2/3}
Call from Testset TEST TESTSETCALL
RF generator level -30 dBm RFGENLEVEL <expr> [<units>]
Timeout 5s TIMEOUT <expr> [<units>]
Use accessory port ON USEACCPORT {ON/OFF}
Set accessory port logic 3 ACCPORT {LOGIC0/1/2/3}
Call type INDIVIDUAL CALLTYPE {INDIVIDUAL/GROUP/
EMERGENCY/ROTATE}
Clear from Testset TEST
TESTSETCLEAR
RF generator level -30 dBm RFGENLEVEL <expr> [<units>]
Timeout 5s TIMEOUT <expr> [<units>]
Use accessory port ON USEACCPORT {ON/OFF}
Set accessory port logic 3 ACCPORT {LOGIC0/1/2/3}
HS data deviation TEST HSDEVN
Status ON STATUS {ON/OFF}
Reference 3.0 kHz REF <expr> [<units>]
Error tolerance 10% ERROR <expr> [<units>]
Data performance TEST
DATAPERFORM
Status ON STATUS {ON/OFF}
RF Gen Level -113 dBm RFGENLEVEL <expr> [<units>]
Lower Limit 95% LOWER <expr> [<units>]
LS data deviation TEST LSDEVN
Status ON STATUS {ON/OFF}
Reference 750 Hz REF <expr> [<units>]
Error tolerance 10% ERROR <expr> [<units>]