WT-9 Dynamic Club S FLIGHT MANUAL Section 8 Page 8-
4. Visually check condition and integrity of wires, check charging – charge battery,
function of the signal bulbs, function of the fuel quantity indicator, fuel drains and
fuel vents for blockages, fuel filters.
5. Visually check condition of the instruments and the avionics ( connector, a plug )
and for correct operation
6. Lubricate according to the Lubrication Chart
7. Check tyres for condition, cuts, uneven or excessive wear and slippage – replace
if need be.
Lubrication Chart
The manufacturer recommends using grease and oil without acid for lubrication only.
Apply the lubricants sparingly without contaminatig of the airframe.
- Check condition of the bearings of the main wheels – clean and lubricate if need
be, at least every 2 years.
- Check condition of the bearings of the nose wheel – clean and lubricate if need be,
at least twice per year.
Lubricate
: Main and rear spar pins
The axle of the nose wheel leg
Guid tube of the flap control lever
The pins of the nose undercarriage leg, the leg support struts
Sparingly lubricate:
The hinges of the control surfaces, movable parts of the control
surfaces, bearings of the ailerons, the pedals and the brake
control lever, all control cables at inlet into the terminations ( in
engine compartment ).
Battery
The powerplant is equipped with an AC generator, which recharges the battery in the
flight. The maintenance-free battery is dry and hermetized; it doesn’t release any
toxic or explosive gas. The battery needs a visual check of the attachment and
security, and inspection for leakage of the electrolyte. The electrolyte contains
mordant vitriol acid, which may cause damage to the airframe and equipment.
Date: 1.12.2001
To Next Page
Loading...
