Aerospool WT-9 Dynamic - Aeroplane Alterations or Repairs; Cleaning and Care; Ground Handling; Road Transport

WT-9 Dynamic Club S FLIGHT MANUAL Section 8 Page 8-
5
8.3 Aeroplane alterations or repairs
It is essential that the responsible airworthiness authority be contacted prior to any
alterations on the aeroplane to ensure that the airworthiness of the aeroplane is not
violated. For repairs refer to the applicable Maintenance Manual. The operator is
allowed replace parts supplied by the producer only. The repairs to damaged skin
must be carried out by qualified staff in accordance with approved procedures.
WARNING
After aeroplane repairs, repainting or mounting of additional
instruments or equipment it is necessary to check weights and
positions of C.G.
8.4 Ground handling / Road transport
The aeroplanes can suffer higher stress loads on the ground than in the air. In this
case can result a potential menace of the safety, as the aeroplane construction is
designed for the manoeuvring load. It is valid for ultralight aeroplane especially. The
high airplane normal accelerations are occurred at the hard landing, during the
taxying at the rough surface and during the driving at the hole road.
Don’t use unnecessary transportation in the road.
CAUTION
The aeroplane is equipped with mooring eyes wh
ich are screwed
into the threaded hubs on the wing lower surface located approx.
half way along the wing. It is also necessary to moor the nose
wheel landing gear.
CAUTION
Push or pull the aeroplane from the propeller
root only, never at the wing tips or the control
surfaces.
8.5 Cleaning and care
Regular cleaning and care of the powerplant, propeller, wings and the airframe is the
first consideration for safe and efficient operation. Cleaning and care should be based
on climatic and flying conditions. The exterior painted surfaces should be cleaned
with clear water using a sponge or soft cotton towel and chamois. These surfaces
should also be protected with a silicone free hard wax reapplied at least once a year
by hand or with a rotating cloth disc.
Clean the Plexiglas canopy only as necessary using a soft cotton towel and clear
water mixed with a small amount of mild detergent. Protect the canopy with anti-
static cleaning agents which are made specifically for Plexiglas.
CAUTION
Do not clean the canopy with alcohol, acetone or lacquer thinner,
because the canopy is made from acrylic.
Acrylic becomes
fragile after contact with these liquids.
Date: 1.12.2001