AES EFI Series - Instruction for Function

18
shows 0. When heat pump has error warning,symbol displays and twinkles, water in area displays P or
E, water out area displays Error code.
Instruction for Function
1. Switch Modes
When heat pump is on,short-press to switch Heat/Cool/Auto,each mode is available for selecting
Boost/Smart/Silent three modes.
2. Set Temperature
When heat pump is on,short-press or into water temperature setting surface. Water in area
temperature value twinkles,press or to select value,press to confirm and exit current setting.No
any set up after 30 seconds,the controller will save the last setting and go back to original surface.
3. Set Parameter
When heat pump is on,Long-press into memu, displays Parameter Query,press or select
among Parameter Query/Parameter Setting/Debugging Status/History Fault.Short-press to confirm your
selction and switch to ,press or select, displays the value.