Afikim Caddy - Programming the Controller

Caddy
66
ATTENTION:
If the acid gel got into your eyes or on your skin despite the precautions
taken, immediately rinse with running water.
The eyes can be washed by using a small glass half filled with water.
Place it over your eye and tilt your head backwards.
Always contact your doctor or a first aid centre near you.
8.9 Programming the controller
The Caddy is equipped with a programmable motor controller. This
controller contains the program settings specific for a comfortable and
safe usage of the Caddy.
The controller is factory programmed to the standard values that should
under normal circumstances not be changed for safety reasons.
In some exceptional cases it may be necessary to change one or more
settings in the programming. This can only be done by a trained
professional who can overview the consequences of the changed
settings.
To be able to reach the controller for programming, you first have to
remove the front cover on the tiller containing the headlight. Take out
the 6 screws located at the back of the tiller . Now pull out the cover to
reach the internal electronic controller .
Connect the connector of the programmer to the controller
(see figure 24): the window shows the connection.