27
AGA Hotcupboard connections
THE HOTCUPBOARD ATTACHMENT REQUIRES A
INDEPEDENT SINGLE PHASE POWER SUPPLY.
n
WARNING: THIS APPLIANCE MUST BE EARTHED.
THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED
ON THE RATING PLATE, WHICH IS SITUATED ON A SLIDE-
OUT TRAY IN THE HOTCUPBOARD BASE PLATE ABOVE THE
PLINTH.
IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED
BY THE MANUFACTURER, ITS SERVICE AGENT OR
SIMILARLY QUALIFIED PERSON TO AVOID A HAZARD.
A 120v ~ 60 Hz, 5 amp fused electrical supply is required
adjacent to the appliance (with the exception of the AGA
Hotcupboard with Induction Hob model, please refer to the
AGA Induction Hob model instructions for the power supply
requirements). External wiring to the unit must be installed
using the mains cable provided, in accordance with the
current wiring regulations and any local regulations which
apply.
The method of connection to the mains electricity supply
must facilitate complete electrical isolation of the appliance,
preferably by a fused double pole switch, having a contact
separation of at least ⁄” (3mm) in both poles.
The isolator should not be positioned immediately above
the hotcupboard, but must be tted with 6ft 6 ¾” of the
appliance.
Power supply - Hotcupboard with induction hob, please refer
to owners manual supplied with the appliance.
To Next Page
Loading...
