36
12. Once the handrail assembly is located squarely, lock the handrail in position by winding in the grub screws on the
underside of each handrail bracket.
13. Once the handrails are locked in position, t the handrail endcaps. The endcaps should be carefully pushed into place
until they sit ush with the outside face of each bracket (a light smear of lubricant such as, washing up liquid on the end
cap ‘O’ rings may ease tment.
14. Finally, t the plinth facia to the magnets on the front of the plinth, making sure that on 5 oven appliances the right hand
side of the module plinth facia sits against the left hand side of the AGA R7 100 plinth facia leaving no gap between.
Make sure that the plinth facias are centrally located and do not overhang either appliance. (Fig. 17.12)
Commission the AGA R7, as stated in the relevant Installation Instructions and carry out functional test on each of the features
of the AGA R7.
To Next Page
Loading...
