36
2921B EN 20031206
Loading films
This section describes how to load the Drystar 5300 with appropriate films.
The Drystar 5300 can be loaded with 11x14” or 14x17” films.
" The Drystar 5300 can be loaded with new films in full daylight. Loading
films is easy and can be done very quickly. Follow the procedures as
described in this section.
The Drystar 5300 will inform you in several ways when a film tray is empty:
• an audible signal,
• the status indicator LED is flashing (red color),
• the display screen shows a message informing you that the input tray is empty.
" The procedure is slightly different, depending on the fact whether the
Drystar 5300 is printing/calculating or in the ready state.
" When the printer is in the ready state, go to Step 3.
Make sure not to load more than one film pack in an input tray. Loading
more than one film pack in the input tray may damage the Drystar 5300.
To Next Page
Loading...
