9
Setting Date & Time
Turn the power on, and set the camera
to the Setup Menu (
page 17).
Select [Date/Time].
Press
or on the five-way control
button to select [Date/Time] and then
press on the five-way control button to
launch the submenu.
Set date and time.
Press or on the five-way control button to change the highlighted value. Press
on the five-way control button to move the cursor between settings.
y Holding down
or changes the values continuously. For date stamp setting
(
page 29).
Apply the setting.
After adjusting the settings, press OK/Enter to apply the setting. Finally press the
MENU button to close the setup menu.
Using the LCD Monitor
The LCD monitor is used to compose images while recording, adjust settings and play
back images. The following indicators may appear on the LCD monitor while recording
or playing back images.
2
4
1
3
T
T
i
i
p
p
s
s
To Next Page
Loading...
Need help?
General
