AgfaPhoto sensor 505-X - Using the Burst-Snapshot

24
Using the Burst-Snapshot
Use this function to take 3 pictures continuously.
Turn the power on, and set the camera to the Capture mode (
page 13).
Open the Capture menu (
page 15).
Change the setting
Press the Mode button to launch the submenu. Press
or on the five-way
control button to select [Burst-Snapshot]. then press OK/Enter to confirm the
setting.
Single: Press the shutter button once to take one picture.
Burst: Press the shutter button once to take three pictures continuously.
Press the MENU button to close the menu list.
Press the shutter button to take a picture series. When using the Burst-Snapshot
function the flash will not work.
4
1
2
3