© Agilent Technologies 2010
Part Number: G4220-90120
*G4220-90120*
*G4220-90120*
Edition: 04/10
Printed in Germany
Agilent Technologies
Hewlett-Packard-Strasse 8
76337 Waldbronn
14 Insert pump piston 15 Insert both pump heads in the link plate and
make sure that the clips snap in that fix the
pump heads.
16 Insert the heat exchanger capillary into the
outlet of the primary pump head. Using a
torque key, set 3 Nm and close the hex screw
at the top of the outlet.
17 Install the pump head assembly and install
flow connections as described in Replacing
the pump heads, discribed in the user Manual.
To Previous Page
Loading...
