Need help?Do you have a question about the Agilent Technologies 5100 ICP-OES and is the answer not in the manual?
General| Wavelength Range | 167 - 785 nm |
|---|---|
| Warm-up Time | Approximately 30 minutes |
| Type | Inductively Coupled Plasma Optical Emission Spectrometer (ICP-OES) |
| Plasma Generator | Solid-state RF generator |
| Detector | Segmented array Charge Coupled Device (CCD) |
| Sample Introduction System | Includes peristaltic pump, nebulizer, and spray chamber |
| Plasma View | Radial and axial view configurations |
| Torch | Demountable torch |
| Auxiliary Gas Flow Rate | 0.5-1.5 L/min |
| Nebulizer Gas Flow Rate | 0.5-1.0 L/min |
| Sample Uptake Rate | 1-2 mL/min |
| Memory Effects | Minimized through efficient spray chamber design and rinse cycles |
| Power Requirements | 200-240 VAC, 50/60 Hz, single phase |
Warns of dangerous voltages in circuits and components, and shock hazards from improper grounding.
Provides a labeled diagram of the front and side of the ICP-OES instrument.
Explains the meaning of different LED colors indicating instrument status and operational readiness.
Describes the LED indicator on the front power button and its states.
Details the installation of ICP Expert software by trained personnel or the user.
Provides step-by-step instructions to connect the ICP Expert software to the instrument.
Refers to the Familiarization DVD or ICP Expert Help for setting up components like pump/torch.
Explains how to assemble and disassemble demountable torch models for cleaning.
Lists sequential steps needed to measure a sample, including PC, instrument, and software setup.
Provides step-by-step instructions for initial power-up and startup of the instrument and software.
Guides on preparing the instrument for analysis, including igniting plasma and setting up the pump.
Details how to perform detector and wavelength calibration procedures.
Instructions on creating new worksheets or opening existing ones for analysis setup.
Guides on configuring features, selecting elements, wavelengths, and analytical conditions.
Provides steps to set up the autosampler and run samples using the ICP Expert software.
Explains how to generate, preview, and print analysis reports using the software.
Guides on cleaning the torch, including acid cleaning for aqueous samples and carbon build-up.
Directs users to the ICP Expert Help for troubleshooting information and procedures.
To Next Page
