Operation
50 Agilent 5100 and 5110 ICP-OES User’s Guide
Printing a Report
To print a report:
1 Click Report on the toolbar or File > Report.
2 Choose whether you want to print or preview the report or save
the report as a PDF file.
TIP
Previewing the report allows you to ensure that you have included all of the
data you require.
3 Select a report template and then click Open.
4 Click the Print button to generate a report as specified. A
message will appear briefly indicating the progress status of the
report being generated.
5 The Print dialog box will then be opened. You can select to print
all of the report, or a range of pages. Reports are printed to your
default printer, unless you specify otherwise. You can specify
your printer options in the Print Setup dialog box, accessible
from the File menu.
Instrument Idle State
In between routine use, it is recommended the instrument be left in
the idle state, which is when the instrument is fully powered but the
plasma off. In this state the polychromator thermostating system and
purge systems remain operational, and the internal air cooling
system runs at reduced capacity. If the ICP-OES is not going to be in
use for a prolonged period of time, fully shutdown the instrument
(which turns off all purging as well as the polychromator
thermostating system).
Setting the instrument to idle
To put the instrument into an idle state:
1 Rinse the spray chamber by aspirating water for a few minutes.
To Next Page
Loading...
Need help?
General
