53220A/53230A User’s Guide 47
53220A/53230A Software Installation and Interface Configuration 2
Figure 2-5. Adding a Sockets Connection.
About IP Addresses and Host Names
Dynamic Host Configuration Protocol (DHCP) and Automatic IP are enabled
on the 53220A/53230A when shipped from Agilent. This allows the instrument
to automatically obtain an address on the network. If there is a DHCP server
on the network, the server will assign the address to the instrument.
If there is not a DHCP server on the network, the 53220A/53230A will auto-
matically determine the address to use. The address will be in the range
169.254.1.1 to 169.254.255.255.
enter and select to add
Socket connection
To Next Page
Loading...
