8
TURN-ON CHECKOUT 31
Introduction 31
Using the Keypad 31
Checkout Procedure 31
In Case of Trouble 34
Error Messages 34
Line Fuse 34
FRONT PANEL OPERATION 35
Introduction 35
Front Panel Description 35
System Keys 37
Function Keys 38
Immediate Action Keys 38
Scrolling Keys 38
Metering Keys 39
Output Control Keys 40
Entry Keys 41
Examples of Front Panel Programming 42
1 - Setting the Output Voltage and Current 42
2 - Querying and Clearing Output Protection 43
3 - Making Front Panel Measurements 43
4 - Programming the Digital Output Port 45
5 - Programming the Output Relay (option 760 only) 46
6 - Setting the GPIB Address and RS-232 Parameters 46
7 - Saving and Recalling Operating States 47
SPECIFICATIONS 49
Specifications 49
Supplemental Characteristics 49
VERIFICATION AND CALIBRATION 53
Introduction 53
Equipment Required 53
Test Setup 53
Performing the Verification Tests 54
Turn-On Checkout 54
Voltage Programming and Measurement Accuracy 55
Current Programming and Measurement Accuracy 55
Performing the Calibration Procedure 59
Front Panel Calibration Menu 59
Front Panel Calibration 59
Calibration Error Messages 62
Changing the Calibration Password 62
Calibration Over the GPIB 63
ERROR MESSAGES 65
LINE VOLTAGE CONVERSION 69
Open the Unit 69
Configure the Power Transformer 69
Install the Correct Line Fuse 69
Close the Unit 70
INDEX 71
To Next Page
Loading...
Need help?
General
