Module 9
Modifying Application Test Definitions
9-31
To Use Auto Analysis Function
Analysis: Auto Analysis
• Line 1
• Line 2
• Marker
GM=GM_MAX
The Auto Analysis statement is used to apply the automatic analysis function to the last test result
before this statement. When the test finishes, the function automatically draws lines, a marker, or
both on the X-Y Graph of the Data Display window. This statement provides the same GUI as the
Auto Analysis setup in the Classic Test.
You can set up two lines and one marker for the automatic analysis function by using the setup
editor.
In the Line 1 and Line 2 areas, you can set up the lines to be drawn.
In the Marker area, you can set up the marker.
This example draws the tangent line for the Y1 data at the maximum GM point.
To Next Page
Loading...
Need help?
General
