Module 9
Modifying Application Test Definitions
9-32
To Control Test Result Data Outputs
Analysis: Data Display Control
Data Display: OFF/ON
Miscellaneous: Data Store Control
Data Store: OFF/ON
By the default setting, the results of the tests defined in your test definition are displayed on the Data
Display window and are stored to the data record.
You can control the data display of the tests by using the Data Display Control statement. Insert the
statement, and remove the check from the Enable Data Display box to disable the data display.
You can also control the data storage of the tests by using the Data Store Control statement. Insert
the statement, and remove the check from the Enable Creating Test Result Record box to disable the
data storage.
The functions cannot control the following data output. They are always enabled.
-Data output by the Test Output of the test definition
-Data output by the last test setup if the Test Output has not been set
To Next Page
Loading...
Need help?
General
