Agilent Technologies B1500A - Page 6

Class Exercises
Class exercises use the test setup listed below. The test setup data are only examples and
included in the Demo.xpg file stored in the Manual CD-ROM.
Module Exercise Device Test setup/definition/data Page
Module 1 no exercise
Module 2 Id-Vd measurement MOSFET CMOS: Id-Vd 2-19, 27
Id-Vg, gm-Vg measurement MOSFET CMOS: Vth gmMax 2-19, 27
B2200/E5250 switch control - - 2-32
Module 3 Id-Vg, gm-Vg measurement MOSFET GMMAX.xtr 3-28
Using Preview window - - 3-31
Module 4 Id-Vd measurement MOSFET Trng Id-Vd 4-25
Multi Channel I/V Sweep
Meas
urement
Bip
olar Tr
LED
Trng Multi 4-37
I/V List Sweep Measurement MOSFET Trng List 4-51
I/V-t sampling measurement 0.1 μF Trng Sampling 4-64
C-V sweep measurement MOSFET Trng CV 4-76
B2200/E5250 switch control - Trng Switch 4-81
Direct Control (C-f measurement) 0.1 μF Trng C-f 4-88
Module 5 Id-Vd measurement MOSFET IDVD, Id-Vd 5-7
SMU series connection 511 kohm IRVR 5-24
SMU parallel connection 1 ohm Parallel 5-28
Re measurement, kelvin connection Bipolar Tr REKELV 5-38
Module 6 Leak current measurement - Zero-check 6-9
Ultra low current measurement - Zero-check-ASU 6-19
Id-Vg measurement MOSFET IDVG 6-20
Gummel plot Bipolar Tr GUMMEL 6-25
Module 7 SMU pulse mode MOSFET IDVD-Pulse 7-8
RC measurement 0.1 μF an
d
511 kohm
RC-samp
ling-log 7-16
Negative hold time 511 kohm R-sampl-neg-hold 7-22
Auto analysis MOSFET GMMAX 7-28
Bias hold function LED LED 7-35
SMU series resistor 511 kohm IV-res 7-43