Agilent Technologies E3631A Service Manual

Chapter 3 Calibration Procedures
Aborting a Calibration in Progress
71
3
Aborting a Calibration in Progress
Sometimes it may be necessary to abort a calibration after the procedure has
already been initiated. You can abort a calibration at any time by turning the
power supply off from the front panel. When performing a calibration from the
remote interface, you can abort a calibration by issuing a remote interface
device clear message or by pressing the front-panel "Local" key.

Agilent Technologies E3631A Specifications

General

Brand	Agilent Technologies
Model	E3631A
Category	Power Supply
Language	English