Chapter 2 Quick Start
To Check the Rated Currents of the Power Supply
27
2
6
Ensure that the current can be adjusted from zero to the maximum
rated value.
1
Adjust the knob until the ammeter indicates 0 amps and then until the ammeter
indicates 7.0 amps.
Note If an error has been detected during the output checkout procedures, the ERROR
annunciator will turn on. See "Error Messages" for more information, starting on
page 121 in chapter 5 of the User's Guide.
1
You can use the resolution selection keys to move the blinking digit to the
right or left when setting the current.
To Next Page
Loading...
Need help?
General
