Chapter 4 Remote Interface Reference
Status Reporting Commands
110
*PSC?
This command queries the power-on status clear setting. The returned
parameter is ‘‘0’’
(*PSC 0
) or ‘‘1’’ (
*PSC 1
).
*SRE <enable value>
This command enables bits in the Status Byte enable register.
*SRE?
This command queries the Status Byte Enable register. The power supply
returns a decimal value which corresponds to the binary-weighted sum of all
bits set in the register.
*STB?
This command queries the Status Byte summary register. The
*STB?
command
is similar to a serial poll but it is processed like any other instrument command.
The
*STB?
command returns the same result as a serial poll but the ‘‘Request
Service’’ bit (bit 6) is not cleared if a serial poll has occurred.
*WAI
This command instructs the power supply to wait for all pending operations
to complete before executing any additional commands over the interface.
Used only in the triggered mode.
To Next Page
Loading...
Need help?
General
