Chapter 4
Front-Panel Key and SCPI Command Reference
Programming Command Compatibility Across Model Numbers and Across Modes
120
Front-Panel Key and SCPI Command
Reference
4.1 Programming Command Compatibility
Across Model Numbers and Across Modes
4.1.1 Across PSA Modes: Command Subsystem Similarities
When you select different modes you get different sets of available programming commands. That is, only the
commands that are appropriate for the current mode are available. Also, some commands have the same syntax
in different modes but have different ranges or settings that are only appropriate to the current mode.
The following table shows which command subsystems are the same across different modes. If there is no “X”
by a particular subsystem, then the set of available commands is different in those modes. Command ranges or
defaults may also be different. Refer to the programming command descriptions in the documentation for each
mode for details.
Command Subsystem Same command set is available:
SA mode compared with the
application modes: Digital
Modulation, Basic, WLAN,
W-CDMA, cdmaOne, cdma2000,
1xEV-DO, GSM, EDGE, NADC,
PDC, or Measuring Receiver
Same command set is available:
SA mode compared with the
application modes: Phase Noise,
Noise Figure, TD-SCDMA
IEEE common commands X X
ABORt X X
CALCulate
CALibration X X
CONFigure
COUPle not available in these application
modes
not available in these application
modes
DISPlay
FETCh
FORMat X
HCOPy X X
INITiate
INPut not available in these application
modes
X
MEASure
MEMory X X
MMEMory X X
To Next Page
Loading...
Need help?
General
