Chapter 2 41
Installation and Setup
N5531S System Requirements
N5531S System Requirements
Table 2-1 PSA System Requirements
System Component Model numbers supported
PSA with Options 233:
Measuring Receiver Personality
E4440A, E4443A, E4445A, E4446A, E4447A and E4448A
Firmware Revision A.09.18 or later (Firmware Version
A.11.11 or later when using the N5532B Sensor Module)
Additional options required to
enhanced performance
a
a. You can also select many other available PSA options. Contact your Agilent sales
office for information on options available for your instrument.
Option 123: mw/mmw preselector bypass above 3 GHz
(Required for signals above 3 GHz, mutually exclusive with
Option AYZ)
Option 1DS: RF pre-amplifier below 3 GHz
(Highly recommended, mutually exclusive with Option 110)
b
Option 110: pre-amplifier
(Highly recommended, mutually exclusive with Option 1DS)
Option 107: audio input
(Required for Audio measurement)
Option N5531S-010: LAN connection kit incl. 1 hub and 3
LAN cables
b. PSA Option 1DS and 110 are mutually exclusive. Option 110 covers the fre-
quency range of 10 MHz to the maximum frequency of the PSA. Option 1DS cov-
ers 100 kHz to 3 GHz.
Table 2-2 Power Meter System Requirements
System Component Model numbers supported Minimum Firmware when using
N5532B Sensor Module
P- Series Power Meter N1911A or N1912A A.05.02
EPM-P Series Power Meter
N4416A or N4417A
a
a. You can use an Agilent EPM or EPM-P Power Meter with a LAN/GPIB Gateway.
A1.05.01/A2.05.01
EPM Series Power Meter
N4418B or N4419B
a
A1.09.01/A2.09.01
To Next Page
Loading...
Need help?
General
