To Next Page

To Previous Page

46 Chapter 2

Instrument Functions: A - L

AMPLITUDE / Y Scale

Instrument Functions: A - L

2.1.8.11 dBpT

Sets the amplitude units to dBpT. This is a unit specifically applicable to EMI field

strength measurements. In the absence of a correction factor this unit is treated by the

instrument exactly as though it were dB

µV. You must load an appropriate correction factor

using amplitude corrections for this unit to generate meaningful results. Therefore, this

key is grayed out unless one of the corrections are turned on (in

Amplitude, Corrections

menu) and

Apply Corrections is set to Yes.

Key Path:

AMPLITUDE / Y Scale, More, Y Axis Units

Dependencies/

Couplings: If the grayed out key is pressed an error message is generated.

History: Added with firmware revision A.06.00

Remote Command:

See “Y Axis Units” on page 41.

Example: UNIT:POW DBPT

2.1.8.12 dBG

Sets the amplitude units to dBG. This is a unit specifically applicable to EMI field strength

measurements. In the absence of a correction factor this unit is treated by the instrument

exactly as though it were dB

µV. You must load an appropriate correction factor using

amplitude corrections for this unit to generate meaningful results. Therefore, this key is

grayed out unless one of the corrections are turned on (in

Amplitude, Corrections menu) and