Chapter 2 65
Instrument Functions: A - L
Auto Couple
Instrument Functions: A - L
2.2.3.4 Optimize LO for Fast Tuning
In this mode, the LO behavior compromises phase noise at all offsets from the carrier
below approximately 2 MHz. This allows rapid measurement throughput when changing
the center frequency or span.
Key Path:
Auto Couple
Remote Command:
See “PhNoise Opt” on page 63.
Example: FREQ:SYNT 3
2.2.4 Detector
See Detector in Det/Demod menu.
Key Path:
Auto Couple
2.2.5 Avg/VBW Type
See Avg/VBW Type in the BW/Avg menu.
Key Path:
Auto Couple
2.2.6 ADC Dither
Access the menu to set ADC Dither to On, Off, or Auto.
Key Path:
Auto Couple
Remote Command:
[:SENSe]:ADC:DITHer[:STATe] OFF|ON|AUTO
[:SENSe]:ADC:DITHer[:STATe]?
Example: :ADC:DITH OFF
To Next Page
Loading...
Need help?
General
