Agilent Technologies G1329A Reference Manual

125
Repairing the Autosampler
Interface Board
Interface Board
CAUTION The interface board is sensitive to electrostatic discharge. Always use the ESD
strap when handling electronic boards.
1 Switch off the autosampler at the main power switch.
2 Disconnect cables from the interface board connectors.
3 Loosen the screws. Slide out the interface board from the autosampler.
4 Install the interface board. Secure the screws.
5 Reconnect the cables to the board connectors
Figure 16 Exchanging the Interface Board
Frequency At installation or when defective.
Tools required Flat-head screwdriver.
Parts required Interface board, see “Optional Interface Boards” on page 228.
Screws

Agilent Technologies G1329A Specifications

General

Brand	Agilent Technologies
Model	G1329A
Category	Laboratory Equipment
Language	English