14
Installing the Autosampler
Site Requirements
A suitable site environment is important to ensure optimal performance of
the autosampler.
Power Consideration
The autosampler power supply has wide-ranging capability. Consequently
there is no voltage selector in the rear of the autosampler. There are also
no externally accessible fuses, because automatic electronic fuses are
implemented in the power supply.
The thermostatted autosampler comprises two modules, the autosampler
and the thermostat (G1330B). Both modules have a separate power supply
and a power plug for the line connections. The two modules are connected
by a control cable and both are turned on by the autosampler module.
WARNING To disconnect the autosampler from line power, unplug the power cord.
The power supply still uses some power, even if the power switch on the
front panel is turned off.
WARNING To disconnect the thermostatted autosampler from line power, unplug
the power cord from the autosampler and the ALS thermostat. The
power supplies still use some power, even if the power switch on the
front panel is turned off. Please make sure that it is always possible to
access the power plug.
WARNING Shock hazard or damage of your instrumentation can result if the
devices are connected to a line voltage higher than specified.
To Next Page
Loading...
Need help?
General
